Impact Crusher

can be widely used in the first and secondary crushing. Compared with hammer crusher, impact crusher has bigger reduction ratio and can fully use the high speed impact energy of entire rotor.

The discharge opening of impact crusher can be adjusted.

Impact crusher

is widely used in water and electricity, expressway, sand and stone, crushing fields. What you should pay attention to is that the impact crusher board hammer is extremely easy to wear; it also is restricted in the hard material stave application. Impact crusher is usually used to break thick garrulous, garrulous or limestone, coal, calcium carbide, quartz, dolomite, curing iron ore, gypsum and some industrial chemicals.

The structure of Impact Crusher includes Rotor, Blow Bar, and Wedge Lock Assembly, Discharge Opening, Liner Plate, First Stage Impact Curtain with Anvils and second、third stage impact curtain with anvils, Impact Curtain Adjusting Rods.

This

impact crusher

crushes materials with impact force. When the materials enter the blow bar area, they are crushed due to the high-speed impact of the blow bar and are thrown to the impact plates on the rotor for secondary crush. Then the materials will be shot back to the blow bar again for the third crush. This process repeats until the materials are crushed to the required size and discharged from the lower part of the impact crusher machine. The size and shape of the finished powder can be changed by adjusting the gap between the impact rack and rotor support. The impact crusher machine employs self-weigh security device in its back frame. When other objects enter the impact cavity, they will be forced out of the crusher machine by the impact rack in the front and back of the crusher machine.

• The impact crusher is of High reduction ratio and crushing efficiency;
• No-board connection; the blow bar with high chrome (high chromed blow bar).
• Impact plate with a special shape for the impact crusher.
• Crushed product from impact crusher is of cubical shape.
• Easy maintenance and reliable operation while using the impact crusher.
• Material which is to be crushed by

  impact crusher

  should be with the side length 500mm and no more than 350Mpa anti-pressure strength.

Type	Spec.	Feeder Opening(mm)	Feeding Size (mm)	Crushing Capacity (t/h)	Motor Power (KW)	Weight (t)
PF-1010	Φ1000×1050	400×1080	350	50-80	55-75	12
PF-1210	Φ1250×1050	400×1080	350	70-120	110-132	14
PF-1214	Φ1250×1400	400×1430	350	130-180	132-160	18.6
PF-1315	Φ1320×1500	860×1520	500	160-250	180-260	19

Note: This specification is just reference, any changes are subject to the JCE series

Impact Crusher

products